Keel Cooling Calculator & Tank Design - Marine Propulsion Engines Beta Marine https://betamarinecanada.com/keel-cooling-calculations/ There are...
It would be helpful to have the OP actually tell us the length, beam considerations and what the service is. The deadrise and beam pretty much...
The lift is constant from when the boat is floating in the water or planing with a reduced wetted surface. ie a boat weighing 3000 pounds at rest...
The second stagnation point occurs within 1/3 pf the leading edge of the rear "hull" behind the step. Similar as on the front section ahead of...
There are two things that contribute to an increase in performance of stepped planing hulls. Consider two constant weight, beam, deadrise and...
Some of the wording is inconsistent and certainly being "10 times as strong as steel" does catch ones imagination But it appears that it is the...
Did you restore the boat in the picture? If so can you post some finished images?
I was under the impression that the OP wanted a curve windshield but perhaps not. There are companies that will curve a window to a specification...
I would stay away from the Acrylic as it tends to crack. Normally starting at the holes for through bolting Lexan is a polycarb and is a much...
Check all of the items that is noted in the previous post. Is your tank a built in? If so, it may have anti siphon valves at the top of the tank....
Hydraulic marine systems; marine propulsion manufacture https://www.hydraulicmarinesystems.com/page/page/4692398.htm This is one of a myriad of...
Your rigger has not mentioned that the main sheet will be taking some of the sail load which reduces the load on the mast. I would not redo any...
Not sure what you mean buckle at the partners. The mast would exhibit the max stress at the base of the mast. The loads and hence stresses would...
Giving this some thought it is not difficult to come up with an aluminum cross section that will carry the load that the existing solid 3 inch...
Is the actual formula on the previous page? Curious as to the constant etc
Just remembered a small but important point The gasket has to be a rubber (not sure if neoprene, ABS etc) as compared to the cork and rubber...
Ohms / Resistance (Empty - Full) Popular Models...
You brought up a good point on copper and brass fittings. Use stainless fittings if you need to.
That would help, but with the draw from the front and the front up, you would not ever get all the fuel out of the tank.
The only problem that I see is that there is not a vent on the top of the tank on the other end of the fill. I am assuming that I see a vent...
